Remove the cleaner dispensing tip from the cleaner head assembly ensuring that the spring in the cleaner head does not fall out. 

After removing the used duster cloth from the lane machine, remove the pipe from the core and insert into the new one.  Unroll about 3 feet of cloth and then install the new roll into its location.

Route the cloth down between the squeegee and the cushion roller.  Pull the cloth under the cushion roller and distribute it evenly. Once the cloth is routed under the cushion roller, pull the excess cloth far enough through to get at least 3 or 4 wraps around the PVC take-up reel or EZ Core. Peel the strip off of the empty core and make sure the cloth is wrapped evenly from side to side around the pipe.

Insert the take-up reel into its location and reinstall the cleaner dispensing tip.

Locate the button inside the cleaner compartment on the 10 pin side wall. This button is always enabled to operate the duster unless the cleaner volume is being checked. Press the button once and the duster will unwind, press again and it will wind-up cloth.  The cloth should be rolled up tight and evenly across the assembly. Keep it pressed to reset the number of lanes left in the cloth.

Note:

After installing the new roll, you must reset the number of lanes in the cloth. Do this by going to your Home screen and tap on the roll of cloth located in the bottom right of the screen. The machine settings will be displayed, tap the cleaning settings at the bottom of the, you will have a button for CLEANER, SQUEEGEE and DUSTER. Tap on the DUSTER button and in the middle of the screen you will have a RESET button. Tap the RESET button and it will prompt you to select OK.