From the home screen, tap the MENU button to display the menu screen. By tapping the PATTERNS button, it will display all of the patterns stored in the machine as well as providing you some additional options. 

By tapping the CREATE NEW PATTERN button, you will be able to access the pattern design screen. At the top you will start by naming your pattern by tapping the small pencil in the lower right corner of pattern name box.

By tapping the footage button, you will set the oil pattern distance, mics, forward start brush and reverse drop brush. Use the left and right arrows to make any changes and tap OK or press the BACK button if no changes were made.

By tapping the 1 on the left side of the screen, it will take you to the forward load screen 1. You can change your starts and stops, loads, mics and speeds. The start distance and the end distance numbers are automatically determined by what is entered into the number of loads and speeds. 

Between the start and stop selection there is a lock. When the lock is displayed as being unlocked, you are able to change the left start and the right stop separately. With the lock is displayed as locked, the stop board will match whatever you change the starting board to.

The number of loads can be changed by either using the left or right arrows for single increments or tap the number itself and a numeric keypad will be displayed. 

The microliters can be changed per loadscreen by pressing the left or right arrow for single increments or tap the number itself and a numeric keypad will be displayed.

The speeds can be changed by using the left or right arrows to increase or decrease by 4 ips (inches per second). By taping the speed number itself a display of speeds will show. To put less strain on your drive motor, it's good practice to have the machine travel forward and reverse without skipping speeds. For example, go from 10 ips to 14 ips and not 10 ips to 18 ips. 

Click OK if this screen is complete and go onto forward load screen 2 and so on. When you are finished with all of the forward loads, press the REVERSE button in the bottom right of the screen.

You will enter the reverse loads the same way you did the forward loads. When you get towards the end of the reverse load, make sure you have enough buff area to enter loads. If not, some speeds may have to be changed to allow for all of the loads to be entered.

After the pattern has been successfully entered, press the USE button and it will ask you to CANCEL, OK or COPY. Press ok if you want to store the pattern or cancel if you want to delete the pattern or 

To scroll through the full library of patterns used throughout the world, tap the Menu button then go to Patterns and tap Online Pattern Library button. From here you will be able to view and download over 700+ patterns from the cloud.